Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 202

Related Commands If the host fails authentication for the designated number of times, the authenticator places the port in authentication failed VLAN (dot1x auth-fail-vlan). NOTE: You can create the Layer 3 portion of a guest VLAN and authentication fail VLANs regardless if the VLAN is assigned to an interface or not. After an interface is assigned a guest VLAN (which has an IP address), routing through the guest VLAN is the same as any other traffic. However, the interface may join/leave a VLAN dynamically. Use this command in Configuration Terminal Batch mode to configure a guest VLAN in a dual-homing setup. ● dot1x auth-fail-vlan ● dot1x reauthentication ● dot1x reauth-max ● show dot1x interface dot1x host-mode Enable single-host or multi-host authentication. C9000 Series Syntax Parameters dot1x host-mode {single-host | multi-host | multi-auth} single-host multi-host multi-auth Enable single-host authentication. Enable multi-host authentication. Enable multi-supplicant authentication. Defaults single-host Command Modes INTERFACE INTERFACE (BATCH MODE) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 8.4.1.0 8.3.2.0 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Added the multi-auth option on the C-Series and S-Series. Added the single-host and multi-host options on the C-Series, E-Series, and S-Series. Usage Information ● Single-host mode authenticates only one host per authenticator port and drops all other traffic on the port. ● Multi-host mode authenticates the first host to respond to an Identity Request and then permits all other traffic on the port. 202 802.1X