Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1054

● For a port extender Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the port-id range is from 1 to 48. ● For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the portid range is 25 to 28 or 49 to 52 depending on the PE. Defaults none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.13.0.1P1 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Introduced peTenGigE interface support on the C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. clear lldp neighbors Clear LLDP neighbor information for all interfaces or a specific interface. C9000 Series Syntax Parameters clear lldp neighbors {interface} interface Enter the following keywords and slot/port or number information: ● For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet then the slot/ port information. ● For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet then the slot/port information. ● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. ● For a Management Ethernet interface, enter the keyword managementethernet then the slot/port information. ● For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then the pe-id / stack-unit / port-id information. ● For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE then the pe-id / stack-unit / port-id information. The pe-id range 1054 Link Layer Discovery Protocol (LLDP)