Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 894

Parameters To delete a crypto policy entry, use the no crypto ipsec policy name seq-num ipsecmanual command. name seq-num Enter the name for the crypto policy set. Enter the sequence number assigned to the crypto policy entry. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 9.2(0.0) Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000, S4810, and S4820T. Usage Information Example This command creates a crypto policy entry and enters the crypto policy configuration mode for configuring the flow parameters. Dell(conf)#crypto ipsec policy West 10 ipsec-manual Dell(conf-crypto-policy)# management crypto-policy Apply the crypto policy to management traffic. C9000 Series Syntax Parameters management crypto-policy name To remove the management traffic crypto policy, use the no management crypto-policy name command. name Enter the name for the crypto policy.. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 9.2(0.0) Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000, S4810, and S4820T. 894 Internet Protocol Security (IPSec)