Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 411

flap-statistics routes received-routes [network [network-mask] (OPTIONAL) Enter the keywords flap-statistics to view flap statistics on the neighbor's routes. (OPTIONAL) Enter the keyword routes to view only the neighbor's feasible routes. (OPTIONAL) Enter the keywords received-routes then either the network address (in dotted decimal format) or the network mask (in slash prefix format) to view all information received from neighbors. NOTE: Configure the neighbor soft-reconfiguration inbound command prior to viewing all the information received from the neighbors. denied-routes [network [network-mask] (OPTIONAL) Enter the keywords denied-routes then either the network address (in dotted decimal format) or the network mask (in slash prefix format) to view all information on routes denied via neighbor inbound filters. Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.4.(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.8.0 8.3.7.0 7.8.1.0 7.7.1.0 7.5.1.0 7.2.1.0 6.3.10 Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Added the ipv4 multicast and ipv6 unicast parameters. Added support for VRF. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Added the add-path option to the S4810. Output on the S4810 shows the ADDPATH parameters. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Added the detail option. Output now displays the default MED value. Added the received and denied route options. The output is changed to display the total number of advertised prefixes. Usage Information After a peer reset, the contents of the notification log messages is displayed in hex values for debugging. The neighbor information that this command displays does not include counts corresponding to ignored prefixes and updates. However, the martian case is an exception where neighbor information corresponding to ignored updates is displayed. BGP shows the exact information that is exchanged between the BGP peers. It also indicates whether or not this information is received by the BGP peer. The following describes the show ip bgp neighbors command shown in the following examples. Border Gateway Protocol 411