Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1429

policy-map-output Create an output policy map. C9000 Series Syntax Parameters policy-map-output policy-map-name To remove a policy map, use the no policy-map-output policy-map-name command. policy-map-name Enter the name for the policy map in character format (32 characters maximum). Defaults none Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.6.1.0 6.1.1.1 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Policy name character limit increased from 16 to 32. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information Related Commands To assign traffic to different flows using QoS policy, use the Output Policy map. This command enables Policy-Map-Output Configuration mode (conf-policy-map-out). Use this command in Configuration Terminal Batch mode to create the Output Policy map in a dualhoming setup. service-queue - assigns a class map and QoS policy to different queues. policy-aggregate - allows an aggregate method of configuring per-port QoS using policy maps. service-policy output - applies an output policy map to the selected interface. qos-policy-input Create a QoS input policy on the router. C9000 Series Syntax qos-policy-input qos-policy-name [layer2] [cpu-qos] To remove an existing input QoS policy from the router, use the no qos-policy-input qospolicy-name [layer2] [cpu-qos] command. Quality of Service (QoS) 1429