Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 303

Related Commands If you configure the set next-hop command with the interface's IP address (either Loopback or physical), the software declares the route unreachable. match ip next-hop - redistributes routes that match the next-hop IP address. set origin To manipulate the BGP ORIGIN attribute, configure a filter. C9000 Series Syntax Parameters set origin {igp | egp | incomplete} To delete an ORIGIN attribute setting, use the no set origin command. egp igp incomplete Enter the keyword egp to set routes originating from outside the local AS. Enter the keyword igp to set routes originating within the same AS. Enter the keyword incomplete to set routes with incomplete routing information. Defaults Not configured. Command Modes ROUTE-MAP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. set tag To specify a tag for redistributed routes, configure a filter. C9000 Series Syntax Parameters set tag tag-value To delete a setting, use the no set tag command. tag-value Enter a number as the tag. The range is from zero (0) to 4294967295. Access Control Lists (ACL) 303