Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1702

61 System Time and Date The commands in this chapter configure time values on the system, either using the Dell Networking operating software, or the hardware, or using the network time protocol (NTP). With NTP, the switch can act only as a client to an NTP clock host. For more information, refer to the "Network Time Protocol" section of the Management chapter in the Dell Networking OS Configuration Guide. Topics: • clock set • clock summer-time date • clock summer-time recurring • clock timezone • debug ntp • ntp authenticate • ntp authentication-key • ntp control-key-passwd • ntp broadcast client • ntp disable • ntp master • ntp offset-threshold • ntp server • ntp source • ntp step-threshold • ntp trusted-key • show clock • show ntp associations • show ntp status • show ntp vrf associations clock set Set the software clock in the switch. C9000 Series Syntax Parameters clock set time month day year time month day year Enter the time in hours:minutes:seconds. For the hour variable, use the 24-hour format; example, 17:15:00 is 5:15 pm. Enter the name of one of the 12 months, in English. You can enter the number of a day and change the order of the display to time day month year. Enter the number of the day. The range is from 1 to 31. You can enter the name of a month to change the order of the display to time month day year. Enter a four-digit number as the year. The range is from 1993 to 2035. Defaults Not configured. Command Modes EXEC Privilege 1702 System Time and Date