Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1036

fefd interval Set an interval between control packets. C9000 Series Syntax Parameters fefd interval seconds To return to the default value, use the no fefd interval command. seconds Enter a number as the time between FEFD control packets. The range is from 3 to 255 seconds. The default is 15 seconds. Defaults 15 seconds Command Modes INTERFACE Command History The following is the Dell Networking OS version history for this command. Version Description 9.9(0.0) Introduced on the C9010. 9.2(1.0) Introduced on the Z9500. 8.3.19.0 Introduced on the S4820T. 8.3.11.1 Introduced on the Z9000. 8.3.7.0 Introduced on the S4810. Related Commands ● fefd - enables far-end failure detection. fefd mode Change the FEFD mode on an interface. C9000 Series Syntax Parameters fefd mode {normal | aggressive}] To return the FEFD mode to the default of normal, use the no fefd mode command. normal aggressive (OPTIONAL) Enter the keyword normal to change the link state to "unknown" when a far-end failure the software detects on that interface. When the interface is placed in "unknown" state, the software brings down the line protocol. (OPTIONAL) Enter the keyword aggressive to change the link state to "errordisabled" when a far-end failure the software detects on that interface. When an interface is placed in "error-disabled" state, enter the fefd reset command to reset the interface state. Defaults normal Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. 1036 Layer 2