Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 169

Example Example Example Example When copying a file to a remote location (for example, using Secure Copy [SCP]), enter only the keywords and Dell Networking OS prompts you for the rest of the information. For example, when using SCP, you can enter copy running-config scp: where running-config is the source and the target is specified in the ensuing prompts. Dell Networking OS prompts you to enter any required information, as needed for the named destination - remote destination, destination filename, user ID, password, etc. When you use the copy running-config startup-config command to copy the running configuration to the startup configuration file, Dell Networking OS creates a backup file on the internal flash of the startup configuration. When you load the startup configuration or a configuration file from a network server such as TFTP to the running configuration, the configuration is added to the running configuration. This does not replace the existing running configuration. Commands in the configuration file has precedence over commands in the running configuration. Dell Networking OS supports copying the running-configuration to a TFTP server, an FTP server, or a remote NFS file system. For example: ● copy running-config tftp: ● copy running-config ftp: ● copy running-config nfsmount:///filepath You can compress the running configuration by grouping all the VLANs and the physical interfaces with the same property. Support to store the operating configuration to the startup config in the compressed mode and to perform an image downgrade without any configuration loss are provided. Two existing exec mode CLIs, show running-config compressed and write memory compressed are enhanced to display and store the running configuration in the compressed mode. From the PE console, you can copy a file to another location using the copy flash: sourcefilename destination-filename. Similarly, you can use the copy usbflash: sourcefilename destination-filename command to copy a file from the external USB flash to another location. In the following copy scp: flash: example, SCP in the first position indicates that the target is to be specified in the ensuing prompts. Entering flash: in the second position indicates that the target is the internal Flash. The source is on a secure server running SSH, so you are prompted for the user datagram protocol (UDP) port of the SSH server on the remote host. Dell#copy running-config scp:/ Address or name of remote host []: 10.10.10.1 Destination file name [startup-config]? old_running User name to login remote host? sburgess Password to login remote host? dilling Dell#copy running-config nfsmount:///filepath Destination file name [test.txt]: User name to login remote host: usrname Password to login remote host: Dell#copy scp: flash: Address or name of remote host []: 10.11.199.134 Port number of the server [22]: 99 Source file name []: test.cfg User name to login remote host: admin Password to login remote host: Destination file name [test.cfg]: test1.cfg Dell#copy compressed-config compressed-cfg ! 6655 bytes successfully copied Dell# Dell#copy compressed-config ftp: Address or name of remote host []: 10.11.8.12 File Management 169