Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 870

Usage Information Version E-Series legacy command Description IGMP commands accept only non-VLAN interfaces - specifying VLAN does not yield results. This command displays packets for IGMP and IGMP snooping. ip igmp access-group Specify access control list for packets in access-group. C9000 Series Syntax Parameters ip igmp access-group access-list To remove the feature, use the no ip igmp access-group access-list command. access-list Enter the name of the extended ACL (16 characters maximum). Defaults Not configured Command Modes INTERFACE (conf-if-interface-slot/port) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.5(0.1) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.6.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information The access list accepted is an extended ACL. The ip igmp access-group command allows you to block IGMP reports from hosts, on a per-interface basis based on the group address and source address that you specify in the access list. ip igmp group-join-limit Set a limit to the number of IGMP groups that can be joined in a second, C9000 Series Syntax Parameters Defaults ip igmp group-join-limit number number Enter the number of IGMP groups permitted to join in a second. The range is from 1 to 10000. none 870 Internet Group Management Protocol (IGMP)