Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 642

lease time Enter the keyword lease then the amount of time the IP address are leased. The range is from 1 to 4294967295. Defaults None Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.13(0.0) 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 8.3.1.0 7.8.1.0 Enhanced the command to map multiple IP addresses to one MAC address. Enhanced to support DHCP snooping in a VLT setup. Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on the E-Series. Introduced on the S4810. Introduced on the E-Series. Introduced on the C-Series and S-Series. Usage Instructions Related Commands You can map multiple IP addresses to the same MAC address. ● show ip dhcp snooping - display the contents of the DHCP binding table. ip dhcp snooping database Delay writing the binding table for a specified time. C9000 Series Syntax Parameters ip dhcp snooping database write-delay minutes minutes The range is from 5 to 21600. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. 642 Dynamic Host Configuration Protocol (DHCP)