Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 211

Version 7.6.1.0 7.4.1.0 Description Introduced on the C-Series and S-Series. Introduced on the E-Series. dot1x tx-period Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits. C9000 Series Syntax Parameters dot1x tx-period seconds To return to the default, use the no dot1x tx-period command. seconds Enter the interval time, in seconds, that EAPOL PDUs are transmitted. The range is from 1 to 65535. The default is 30. Defaults 30 seconds Command Modes INTERFACE INTERFACE (BATCH MODE) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 7.6.1.0 7.4.1.0 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. mac Configure a list of supplicant MAC addresses for dot1x profile represented with a profile-name. Syntax Parameters [no] mac {mac-address1 mac-address2... mac-address6} mac-address1 mac-address2... mac-address6 Enter the keyword mac and type the 48- bit MAC addresses using the H.H.H format. A maximum of 6 MAC addresses are allowed. Defaults None Command Modes DOT1X PROFILE CONFIG (conf-dot1x-profile) CONFIGURATION TERMINAL BATCH 802.1X 211