Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1055

is from 0 to 255; the stack-unit unit-number range is from 0 to 7; and the portid range is 25 to 28 or 49 to 52 depending on the PE. Defaults none Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.13.0.1P1 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Introduced peTenGigE interface support on the C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. debug lldp interface To display timer events, neighbor additions or deletions, and other information about incoming and outgoing packets, enable LLDP debugging. Syntax debug lldp interface {interface | all}{events | packet {brief | detail} {tx | rx | both}} To disable debugging, use the no debug lldp [interface {interface | all}{events} {packet {brief | detail} {tx | rx | both}}] command. Parameters interface interface Enter the following keywords and slot/port or number information: ● For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. ● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. all events packet brief detail tx rx both Enter the keyword all to display information on all interfaces. Enter the keyword events to display major events such as timer events. Enter the keyword packet to display information regarding packets coming in or going out. Enter the keyword brief to display brief packet information. Enter the keyword detail to display detailed packet information. Enter the keyword tx to display transmit-only packet information. Enter the keyword rx to display receive-only packet information. Enter the keyword both to display both receive and transmit packet information. Defaults None Link Layer Discovery Protocol (LLDP) 1055