Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1059

Related Commands Version 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Description Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. protocol lldp (Configuration) - enables LLDP globally. show lldp neighbors - displays the LLDP neighbors. multiplier Set the number of consecutive misses before LLDP declares the interface dead. C9000 Series Syntax Parameters multiplier integer To return to the default, use the no multiplier integer command. integer Enter the number of consecutive misses before the LLDP declares the interface dead. The range is from 2 to 10. Defaults 4 x hello Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.7.1.0 7.6.1.0 7.4.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. pe-lldp-multiplier Configure the port extender (PE) LLDP multiplier value. Syntax pe-lldp-multiplier number Link Layer Discovery Protocol (LLDP) 1059