Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1239

Usage Information Version 7.8.1.0 7.4.1.0 8.3.19.0 Description Added support for C-Series. Introduced on the E-Series. Introduced on the S4820T. In general, the path cost is calculated as: 10^8 / bandwidth Using this formula, the default path cost is calculated as: ● 10-Gigabit Ethernet-Default cost is 1 ● 40-Gigabit Ethernet - Default cost is 1 ipv6 ospf dead-interval Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare the router down. C9000 Series Syntax Parameters ipv6 ospf dead-interval seconds To return to the default time interval, use the no ipv6 ospf dead-interval command. seconds Enter the time interval in seconds. The range is from 1 to 65535 seconds. Defaults 40 seconds (Ethernet). Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 9.1.(0.0) 7.8.1.0 7.4.1.0 8.3.19.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4810 and Z9000. Added support for C-Series. Introduced on the E-Series. Introduced on the S4820T. Usage Information Related Commands By default, the dead interval is four times longer than the default hello-interval. ipv6 ospf hello-interval - specifies the time interval between hello packets. Open Shortest Path First (OSPFv2 and OSPFv3) 1239