Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1461

Usage Information Example Related Commands Version 7.5.1.0 6.2.1.1 Description Introduced on the C-Series. Introduced on the E-Series. RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the no disable command from RSTP mode. Dell(conf)#protocol spanning-tree rstp Dell(config-rstp)##no disable disable - disables RSTP globally on the system. show config View the current configuration for the mode. Only non-default values are displayed. C9000 Series Syntax show config Command Modes CONFIGURATION RSTP (conf-rstp) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Example Dell(conf-rstp)#show config ! protocol spanning-tree rstp no disable bridge-priority 16384 Rapid Spanning Tree Protocol (RSTP) 1461