Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 508

show cam-acl-egress-pe Display details of the global egress CAM ACL profiles for the port extender. C9000 Series Syntax show cam-acl-egress-pe Defaults None Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) Introduced on the C9010. Usage Information Example The display reflects the settings implemented with the cam-acl-egress-pe command. This command only displays the details of CAM ACL egress profiles configured globally on the PE. It does not display CAM ACL egress profiles for each PE. Dell# show cam-acl-egress-pe -- Port extender Egress Cam ACL -- Current Settings(in block sizes) 1 block = 256 entries L2Acl : 1 Ipv4Acl : 1 Ipv6Acl : 2 test cam-usage Verify the CAM space that is available for IPv4 and IPv6 CAM profiles, and particularly to verify if enough CAM space is available for the IPv6 ACLs you use in a policy map. C9000 Series Syntax Parameters test cam-usage service-policy input policy-map-name linecard {number portset {port-pipe-number} | all} input policymap-name linecard number portset portpipe-number Enter the name of the policy map to verify. Maximum is 32 characters. Enter a line card and port-pipe number to check CAM usage on specified ports. The range of valid port-pipe numbers is 0 to 3. Enter linecard all to verify the CAM space available for all ports on the switch. Defaults None Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. 508 Content Addressable Memory (CAM)