Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1043

Version 9.2(1.0) 8.3.19.0 8.3.11.1 8.5.1.0 8.3.7.0 7.6.1.0 7.5.1.0 6.2.1.1 Description Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Added support for 4-port 40G line cards on ExaScale. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. lacp long-timeout Configure a long timeout period (30 seconds) for an LACP session. C9000 Series Syntax lacp long-timeout To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command. Defaults 1 second Command Modes INTERFACE (conf-if-po-number) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 6.2.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Related Commands This command applies to dynamic port-channel interfaces only. When applied on a static port-channel, this command has no effect. show lacp - displays the LACP configuration. Link Aggregation Control Protocol (LACP) 1043