Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 936

Usage Information Example Version 8.3.7.0 8.1.1.2 8.1.1.0 7.9.1.0 7.5.1.0 6.1.1.0 Description Introduced on the S4810. Introduced on the E-Series ExaScale E600i. Introduced on the E-Series ExaScale. Introduced VRF on the E-Series. Introduced on the C-Series. Introduced on the E-Series. The following describes the show ip cam command shown in the following example. Field Description Index Displays the CAM index number of the entry. Destination Displays the destination route of the index. EC Displays the number of equal cost multipaths (ECMP) available for the default route for non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is more than eight. CG Displays 0. V Displays a 1 if the entry is valid and a 0 if the entry is for a line card with Catalog number beginning with LC-EF. C Next-Hop Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the CP or RP2, depending on Egress port. Displays the next hop IP address of the entry. VId Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN. Mac Addr Port Displays the next-hop router's MAC address. Displays the egress interface. Use the second half of the entry to determine the interface. For example, in the entry 17cl CP, the CP is the pertinent portion. ● CP = control processor ● RP2 = route processor 2 ● Gi = Gigabit Ethernet interface ● So = SONET interface ● Te = 10-Gigabit Ethernet interface Dell#show ip cam linecard 0 port‐set 0 Destination EC C VId Mac‐Addr Port 1.1.32.140/32 0 0 200 00:00:00:00:1f:8a PeGigE // show ip fib linecard View all forwarding information base (FIB) entries. C9000 Series Syntax Parameters show ip fib linecard linecard id {vrf //summary} linecard Displays the fib entries for the mentioned linecard id. 936 IPv4 Routing