Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1776

● vrrp-ipv6-group The following commands apply to IPv4 and IPv6: ● advertise-interval ● clear counters vrrp ipv6 ● description ● disable ● hold-time ● preempt ● priority ● show config ● virtual-address clear counters vrrp ipv6 Clear the counters recorded for IPv6 VRRP groups. C9000 Series Syntax Parameters clear counters vrrp ipv6 [vrid | vrf instance] vrid vrf instance (OPTIONAL) Enter the number of an IPv6 VRRP group. The range is from 1 to 255. (OPTIONAL) Enter the name of a VRF instance (32 characters maximum) to clear the counters of all IPv6 VRRP groups in the specified VRF. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2.(1.0) 8.3.19.0 8.3.10.0 8.4.1.0 8.3.2.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on E-Series ExaScale, C-Series, and S-Series. Support was added for IPv6 VRRP groups in non-default VRF instances. Introduced on the E-Series TeraScale. debug vrrp ipv6 Enable debugging of VRRP. C9000 Series Syntax Parameters debug vrrp ipv6 interface [vrid] {all | packets | state | timer} interface Enter the following keywords and slot/port or number information: ● For a Port Channel interface, enter the keywords port-channel then a number. 1776 Virtual Router Redundancy Protocol (VRRP)