Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 513

Command History Usage Information This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.8.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. To display the per-protocol counters of rate-limited control-plane traffic at the aggregated (switch) or line card and port set level, use the show control-traffic protocol command. clear control-traffic queue Clear per-queue counters of rate-limited control-plane traffic. C9000 Series Syntax Parameters clear contol-traffic queue {all | queue-number} counters all queue-number Enter the keyword all to clear counters for rate-limited traffic on all CPU queues, including Route Processor, Control Processor, and line-card CPUs. Enter the queue number to clear counters for rate-limited traffic on a specified CPU queue. The range of queue-number values is from 0 to 20. The twenty-one control-plane queues are divided into groups of seven queues for the Route Processor, Control Processor, and line-card CPUs as follows: ● Queues 0 to 6 process packets destined to the Control Processor CPU . ● Queues 7 to 13 process packets destined to the Route Processor CPU. ● Queues 14 to 20 process packets destined to the line card CPU. Defaults Clear per-queue rate-limiting counters for all control-plane and port traffic. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.8.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Usage Information To display the per-queue counters of rate-limited control-plane traffic at the aggregated (switch), use the show control-traffic queue command. Control Plane Policing (CoPP) 513