Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 288

● For a Port Channel interface, enter the keyword port-channel then a number. The range is from 1 to 128. ● For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information. ● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information. ● For a VLAN, enter the keyword vlan then a number from 1 to 4094 (you can use IDs 1 to 4094). Defaults Not configured. Command Modes ROUTE-MAP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.5.1.0 8.1.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added support for 4-port 40G line cards on ExaScale. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Related Commands match ip address - redistributes routes that match an IP address. match ip next-hop - redistributes routes that match the next-hop IP address. match ip route-source - redistributes routes that match routes advertised by other routers. match metric - redistributes routes that match a specific metric. match route-type - redistributes routes that match a route type. match tag - redistributes routes that match a specific tag. match ip address To match routes based on IP addresses specified in an access list, configure a filter. C9000 Series Syntax Parameters match ip address prefix-list-name To delete a match, use the no match ip address prefix-list-name command. prefix-list-name Enter the name of configured prefix list, up to 140 characters. Defaults Not configured. Command Modes ROUTE-MAP 288 Access Control Lists (ACL)