Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 285

Usage Information Related Commands Version 8.3.7.0 8.1.1.0 7.6.1.0 7.5.1.0 7.4.1.0 Description Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. The continue feature allows movement from one route-map entry to a specific route-map entry (the sequence number). If you do not specify the sequence number, the continue feature simply moves to the next sequence number (also known as an implied continue). If a match clause exists, the continue feature executes only after a successful match occurs. If there are no successful matches, the continue feature is ignored. Match clause with Continue clause The continue feature can exist without a match clause. A continue clause without a match clause executes and jumps to the specified route-map entry. With a match clause and a continue clause, the match clause executes first and the continue clause next in a specified route map entry. The continue clause launches only after a successful match. The behavior is: ● A successful match with a continue clause, the route map executes the set clauses and then goes to the specified route map entry upon execution of the continue clause. ● If the next route map entry contains a continue clause, the route map executes the continue clause if a successful match occurs. ● If the next route map entry does not contain a continue clause, the route map evaluates normally. If a match does not occur, the route map does not continue and falls through to the next sequence number, if one exists. Set Clause with Continue Clause If the route-map entry contains sets with the continue clause, set actions are performed first then the continue clause jumps to the specified route map entry. ● If a set action occurs in the first route map entry and then the same set action occurs with a different value in a subsequent route map entry, the last set of actions overrides the previous set of actions with the same set command. ● If set community additive and set as-path prepend are configure, the communities and AS numbers are prepended. set community - specifies a COMMUNITY attribute. set as-path - configures a filter to modify the AS path. description Add a description to this route map. C9000 Series Syntax Parameters description {description} To remove the description, use the no description {description} command. description Enter a description to identify the route map (80 characters maximum). Defaults none Command Modes ROUTE-MAP Access Control Lists (ACL) 285