Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 962

packets on one port and forwards (mirrors) them to another port. The source port is the monitored port (MD) and the destination port is the monitoring port (MG). ipv6 access-list Configure an access list based on IPv6 addresses or protocols. C9000 Series Syntax Parameters ipv6 access-list access-list-name To delete an access list, use the no ipv6 access-list access-list-name command. access-list-name Enter the access list name as a string, up to 140 characters. Defaults All access lists contain an implicit "deny any"; that is, if no match occurs, the packet is dropped. Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.7.0 8.4.2.1 8.2.1.0 7.8.1.0 7.4.1.0 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the S-Series. Introduced on the E-Series ExaScale. Introduced on the C-Series. Increased the name string to accept up to 140 characters. Prior to version 7.8.1.0, names are up to 16 characters long. Introduced on the E-Series TeraScale. Usage Information Related Commands The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries allowed per ACL, refer to your line card documentation. Use this command in Configuration Terminal Batch mode to configure the access list in a dual-homing setup. show config - views the current configuration. 962 IPv6 Access Control Lists (IPv6 ACLs)