Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 209

Usage Information Version 8.3.11.1 7.6.1.0 7.4.1.0 Description Introduced on the Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. When you configure the dot1x server-timeout value, take into account the communication medium used to communicate with an authentication server and the number of RADIUS servers configured. Ideally, the dot1x server-timeout value (in seconds) is based on the configured RADIUS-server timeout and retransmit values and calculated according to the following formula: dot1x servertimeout seconds > (radius-server retransmit seconds + 1) * radius-server timeout seconds. Where the default values are as follows: dot1x server-timeout (30 seconds), radius-server retransmit (3 seconds), and radius-server timeout (5 seconds). For example: Dell(conf)#radius-server host 10.11.197.105 timeout 6 Dell(conf)#radius-server host 10.11.197.105 retransmit 4 Dell(conf)#interface tengigabitethernet 2/23 Dell(conf-if-te-2/23)#dot1x server-timeout 40 Use this command in Interface Batch Mode to configure the server time-out in a dual-homing setup. dot1x static-mab Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface. Syntax Parameters [no] dot1x static-mab profile profile-name profile profilename Enter the keyword profile and the profile-name to configure the static MAB profile name. The profile name length is limited to 32 characters. Defaults Disabled. Command Modes INTERFACE INTERFACE (BATCH MODE) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) Introduced on the S3100 series, S4048-ON, S4048-ON, S4810, S4820T, S5000, S6000, S6000-ON, the Configuration Terminal Batch mode on C9010, Z9100-ON, and Z9500. Introduced on the C9010. Usage Information The dot1x static-mab command enables static MAB (mac auth bypass) and configures the associated profile on a dot1x interface. Static MAB bypasses the authentication server for the supplicant MAC addresses configured in the associated profile. Before you enable static MAB, you must do the following: ● Enable MAC authentication bypass on the port by configuring the dot1x mac-auth-bypass command. ● Ensure that no configured profile exists at the time of configuring the static-mab command. ● Use this command in Interface Batch Mode to enable static MAB in a dual-homing setup. 802.1X 209