Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1430

Parameters qos-policy-name layer2 cpu-qos Enter the name for the policy map in character format (32 characters maximum). (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The default is Layer 3. Enter the keyword cpu-qos to create a QoS input policy to be used to rate-limit control-plane traffic (CoPP). Defaults Layer 3 Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.6.1.0 7.5.1.0 6.1.1.1 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Policy name character limit increased from 16 to 32. Introduced on the C-Series and S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Related Commands To specify the name of the input QoS policy, use this command. After the input policy is specified, ratepolice is defined. This command enables Qos-Policy-Input Configuration mode - (conf-qos-policy-in). When changing a Service-Queue configuration in a QoS policy map, all QoS rules are deleted and readded automatically to ensure that the order of the rules is maintained. As a result, the Matched Packets value shown in the show qos statistics command is reset. If you create create a QoS input policy to be used for CoPP, you must enter the keyword cpu-qos. Use this command in Configuration Terminal Batch mode to create the QoS input policy in a dual-homing setup. rate police - incoming traffic policing function. qos-policy-output Create a QoS output policy. C9000 Series Syntax Parameters qos-policy-output qos-policy-name To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name command. qos-policy-name Enter your output QoS policy name in character format (32 characters maximum). 1430 Quality of Service (QoS)