Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 942

show ip management-route View the IP addresses assigned to the Management interface. C9000 Series Syntax Parameters show ip management-route [all | connected | summary | static] all connected summary static (OPTIONAL) Enter the keyword all to view all IP addresses assigned to all Management interfaces on the switch. (OPTIONAL) Enter the keyword connected to view only routes directly connected to the Management interface. (OPTIONAL) Enter the keyword summary to view a table listing the number of active and non-active routes and their sources. (OPTIONAL) Enter the keyword static to view non-active routes also. Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.5.1.0 6.1.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series. Introduced on the E-Series. Example Dell#show ip management-route Destination ----------10.1.2.0/24 172.16.1.0/24 Dell# Gateway ------ManagementEthernet 0/0 10.1.2.4 State ----Connected Active show ipv6 management-route Display the IPv6 static routes configured for the management interface. C9000 Series Syntax show ipv6 management-route [all | connected | summary | static] 942 IPv4 Routing