Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 205

Related Commands Version 8.4.1.0 dot1x host-mode Description Introduced on the C-Series and S-Series. dot1x port-control Enable port control on an interface. C9000 Series Syntax Parameters dot1x port-control {force-authorized | auto | force-unauthorized} force-authorized Enter the keywords force-authorized to forcibly authorize a port. auto Enter the keyword auto to authorize a port based on the 802.1X operation result. forceunauthorized Enter the keywords force-unauthorized to forcibly deauthorize a port. Defaults none Command Modes INTERFACE INTERFACE (BATCH MODE) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.12.0 8.3.11.1 7.6.1.0 7.4.1.0 Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information The authenticator completes authentication only when port-control is set to auto. Use this command in Interface Batch Mode to enable port control on an interface in a dual-homing setup. dot1x profile Configure a dot1x profile to define a list of trusted supplicant MAC addresses. Syntax Parameters [no] dot1x profile profile-name profile-name Enter a dot1x profile-name. The profile name length is limited to 32 characters. Defaults None 802.1X 205