Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1310

Example Version 8.4.1.0 Description Introduced Dell(conf)# ip access-list standard map1 Dell(config-std-nacl)# permit 224.0.0.1/24 Dell(config-std-nacl)#exit Dell(conf)#int tengig 1/1 Dell(config-if-te-1/1)# ip pim ingress-interface-map map1 ip pim neighbor-filter To prevent a router from participating in protocol independent multicast (PIM), configure this feature. C9000 Series Syntax Parameters ip pim neighbor-filter {access-list} To remove the restriction, use the no ip pim neighbor-filter {access-list} command. access-list Enter the name of a standard access list. Maximum 16 characters. Defaults none Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.5(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 7.6.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series ExaScale. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information Do not enter this command before creating the access-list. ip pim query-interval Change the frequency of PIM Router-Query messages. C9000 Series Syntax ip pim query-interval seconds 1310 PIM-Sparse Mode (PIM-SM)