Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1139

Example Version 9.8(0.0) 9.7(0.0) 8.3.12.0 8.4.1.0 Description Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the S4810. Introduced. Dell#debug track all 04:35:04: %RPM0-P:RP2 %OTM-5-STATE: track 6 - Interface TenGigabitEthernet 1/2/1 line-protocol DOWN 04:35:04: %RPM0-P:RP2 %OTM-5-NOTIF: VRRP notification: resource ID 6 DOWN delay Configure the time delay used before communicating a change in the status of a tracked object to clients. C9000 Series Syntax Parameters delay {[up seconds] [down seconds]} To return to the default setting, use the no delay command. seconds Enter the number of seconds the object tracker waits before sending a notification about the change in the UP and/or DOWN state of a tracked object to clients. The range is 0 to 180. The default is 0 seconds. Defaults 0 seconds Command Modes OBJECT TRACKING (conf_track_object-id) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.8(0.0) 9.7(0.0) 8.3.12.0 8.4.1.0 Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the S4810. Introduced. Usage Information To set the time delay before a change in the state of a tracked object is communicated to clients configure an UP and/or DOWN timer for each tracked object. The configured time delay starts when the state changes from UP to DOWN or vice-versa. If the state of an object changes back to its former UP/DOWN state before the timer expires, the timer is cancelled and the client is not notified. For example, if the DOWN timer is running when an interface goes down and comes back up, the DOWN timer is cancelled and the client is not notified of the event. If the timer expires and an object's state has changed, a notification is sent to the client. If you do not configure a delay timer, a notification is sent immediately after a change in the state of a tracked object is detected. The time delay in communicating a state change is specified in seconds. Object Tracking 1139