Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1107

ip msdp sa-limit Configure the upper limit of source-active (SA) entries in SA-cache. C9000 Series Syntax Parameters ip msdp sa-limit number To return to the default, use the no ip msdp sa-limit number command. number Enter the maximum number of SA entries in SA-cache. The range is from 0 to 40000. Defaults 50000 Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.5(0.1) 8.3.19.0 8.3.11.1 8.3.7.0 7.5.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Usage Information Related Commands The system counts the SA messages originated by itself and those messages received from the MSDP peers. When the total SA messages reach this limit, the subsequent SA messages are dropped (even if they pass RPF checking and policy checking). If the total number of SA messages is already larger than the limit when this command is applied, those SA messages that are already in the system continue to be accepted. To enforce the limit in such situation, use the clear ip msdp sa-cache command. ip msdp peer - configures the MSDP peer. clear ip msdp peer - clears the MSDP peer. show ip msdp - displays the MSDP information ip msdp shutdown Administratively shut down a configured MSDP peer. C9000 Series Syntax Parameters ip msdp shutdown {peer address} peer address Enter the peer address in a dotted decimal format (A.B.C.D.). Defaults Not configured. Command Modes CONFIGURATION Multicast Source Discovery Protocol (MSDP) 1107