Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 881

show ip igmp ssm-map Display is a list of groups that are currently in the IGMP group table and contain SSM mapped sources. C9000 Series Syntax Parameters show ip igmp ssm-map [group] group (OPTIONAL) Enter the multicast group address in the form A.B.C.D to display the list of sources to which this group is mapped. Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 Introduced on the C9010. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the C-Series and S-Series. Introduced on the E-Series. Example Dell#show ip igmp ssm-map Interface Vlan 20 Group 232.1.1.5 Uptime 00:11:22 Expires Never Router mode INCLUDE Last reporter 35.0.0.2 Group source list Source address Expires 65.0.0.1 00:01:22 65.0.0.2 00:01:22 65.0.0.3 00:01:22 65.0.0.4 00:01:22 65.0.0.5 00:01:22 Related Commands ip igmp ssm-map - uses a statically configured list to translate (*,G) memberships to (S,G) memberships. IGMP Snooping Commands IGMP Snooping version 2 and 3 are supported on the switch. Important Points to Remember for IGMP Snooping ● The Dell Networking OS supports version 1, version 2, and version 3 hosts. ● The IGMP snooping implementation is based on IP multicast address (not based on Layer 2 multicast mac address) and the IGMP snooping entries are in Layer 3 flow table not in Layer 2 forwarding information base (FIB). Internet Group Management Protocol (IGMP) 881