Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1783

ip vrf forwarding Attach an interface to a configured VRF. C9000 Series Syntax Parameters ip vrf forwarding {vrf-name | management} To delete an interface associated with a configured VRF, use the no ip vrf forwarding {vrfname | management} command. vrf-name management Enter name of the VRF that you want to associate the interface to. Use this keyword when you want to associate the interface to the management VRF. Defaults None (Interface is part of default VRF). Command Modes INTERFACE-CONFIG Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.4.(0.0) Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON and Z9500. Introduced on the S-Series and Z9000. Usage Information Use this command to attach an interface to a configured VRF. You can attach an interface to either a non-default VRF or a management VRF. To assign a port-back to a default VRF, remove VRF association from the interface. You can use this only if there is no IP address configured on the interface. There must be no prior Layer 3 configuration on the interface when configuring VRF. VRF must be enabled prior to implementing this command. You can configure an IP subnet or address on a physical or VLAN interface that overlaps the same IP subnet or address configured on another interface only if the interfaces are assigned to different VRFs. If two interfaces are assigned to the same VRF, you cannot configure overlapping IP subnets or the same IP address on them. ip route-export Enable route leaking between VRFs. Export or share IPv4 routes corresponding to one VRF with other non-default VRFs. C9000 Series Syntax Parameters ip route-export tag [route-map-name] route-export tag route-map-name Enter the route-export keyword to leak or share routes between VRFs. Enter a tag (export route target) to expose routes to other VRFs. This tag acts as an identifier for exported routes. You can use this identifier while importing these routes into another non-default VRF. (Optional) Enter the name of the route-map to filter the exported routes. Virtual Routing and Forwarding (VRF) 1783