Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1563

Usage Information Version 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. This command specifies the maximum number of attempts to authenticate a user on an SSH connection with the remote host for password authentication. SSH disconnects when the number of password failures exceeds authentication-retries. ip ssh challenge-response-authentication Enable challenge response authentication for SSHv2. Syntax ip ssh challenge-response-authentication enable To disable the challenge response authentication, use the no ip ssh challenge-responseauthentication enable command. Parameters enable Enter the keyword enable to enable the challenge response authentication for SSHv2. Defaults Disabled. Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.11(0.0) Introduced on the S4810, S4820T, S3048-ON, S3100 Series, S4048-ON, S5000, S6000, S6000-ON, Z9500, Z9100-ON, S6100-ON, S6010-ON, S4048T-ON, C9000, and MXL. Usage Information If both the challenge response authentication and password authentication methods are configured, the challenge response authentication takes priority. NOTE: SSHv1 does not support challenge response authentication. ip ssh cipher Configure the list of ciphers supported on both SSH client and SCP. Syntax Parameters ip ssh cipher cipher-list cipher cipher-list Enter the keyword cipher and then a space-delimited list of ciphers that the SSH client supports. The following ciphers are available. ● aes256-ctr ● aes256-cbc ● aes192-ctr ● aes192-cbc ● aes128-ctr ● aes128-cbc ● 3des-cbc Defaults The default list of ciphers is in the order as shown below: Security 1563