Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1697

start-time HH:MM stop-time HH:MM Enter the keywords start-time then a starting time expressed as HH:MM. Use the 24-hour clock format. Enter the keywords stop-time then a stopping time expressed as HH:MM. Use the 24-hour clock format. Command Modes SUPPORTASSIST PERSON Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version Description 9.11(0.0) 9.10(0.0) 9.9(0.0) Introduced on the M I/O Aggregator and FN IOM. Introduced on the C9010, Z9100-ON, S6100-ON, and S3100 series. Introduced on the S4810, S4820T, S3048-ON, S4048-ON, S5000, S6000, S6000-ON, Z9500, MXL. Usage Information This command is optional for SupportAssist service configuration. SupportAssist Server Commands Dell Networking OS supports the following SupportAssist Server mode commands. proxy-ip-address Configure a proxy for reaching the SupportAssist remote server. Syntax proxy-ip-address {ipv4-address | ipv6-address} port port-number [ username userid password [encryption-type] password ] To remove the proxy, use the no proxy-ip-address command. Parameters ipv4-address ipv6-address Enter the IP address of the proxy server in a dotted decimal format (A.B.C.D). Enter the IPv6 address of the proxy server in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. NOTE: To use the IPv6 address, the Open Automation package should also support IPv6 communications. For this purpose, SupportAssist requires Dell Networking Open Automation 9.10(0.0) package or later. port port-number Enter the keyword port then the TCP/IP port number. The port number range is from 1024 to 65534. username userid (OPTIONAL) Enter the keyword username then the user ID used for the proxy server. password Enter the keyword password then the encryption-type or the user password. encryption-type (OPTIONAL) Enter an encryption type for the password you enter. ● 0 directs the system to interpret the password as clear text. ● 7 indicates that the password is encrypted using a DES hashing algorithm. password Enter a string up to 32 characters long. Defaults encryption-type for the password is 0. Command Modes SUPPORTASSIST SERVER SupportAssist 1697