Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1060

Parameters To return to the default multiplier value, use the no pe-lldp-multiplier command. number Modify the number to change the PE LLDP multiplier value. The range is from 3 to 10. Defaults 3 Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version Description 9.14(1.6) Introduced on the C9010. Usage Information Example (configure the PE LLDP multiplier) PE LLDP timeout is based on the hello interval and multiplier value (for example: Default Hello interval: 3 seconds * multiplier: 3 seconds). This command allows you to change the multiplier value only. DellEMC(conf)#pe-lldp-multiplier ? Multiplier value (default = 3) DellEMC(conf)#pe-lldp-multiplier 5 DellEMC(conf)# DellEMC(conf)#do show running-config | grep pe- pe-lldp-multiplier 5 DellEMC(conf)# Example (unconfigure the PE LLDP multiplier) DellEMC(conf)#no pe-lldp-multiplier DellEMC(conf)# DellEMC(conf)#do show running-config | grep peDellEMC(conf)# protocol lldp (Configuration) Enable the LLDP globally on the switch. C9000 Series Syntax protocol lldp To disable LLDP globally on the chassis, use the no protocol lldp command. Defaults Enabled. Command Modes CONFIGURATION(conf-lldp) CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) 9.2(1.0) Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Introduced on the Z9500. 1060 Link Layer Discovery Protocol (LLDP)