Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 165

4 File Management This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as other file management commands. The commands in this chapter are supported by the Dell Networking OS on the C9000 switch. Topics: • boot system • cd • copy • delete • dir • format flash • mkdir • mount nfs • pwd • rename • restore factory-defaults • rmdir • show boot bmp • show boot system • show bootvar • show file • show file-systems • show os-version • show running-config • show startup-config • upgrade • upgrade system-image-os6 • verify boot system Specify the location where the Dell Networking OS image used to boot the system is stored. C9000 Series Syntax Parameters boot system [gateway ip address | [rpm0 {default | primary |secondary [ftp: | system:{A:| B:} | tftp:] }] [rpm1 {default | primary | secondary [ftp: | system:{A:|B:} | tftp:]}] gateway ip-address rpm0 rpm1 default primary Enter the IP address of the default next-hop gateway for the management subnet. Enter an IP address in dotted decimal format. Enter the keyword rpm0 to specify the route processor module 0. Enter the keyword rpm1 to specify the route processor module 1. Enter the keyword default to use the default Dell Networking OS image. Enter the keyword primary to use the primary Dell Networking OS image. File Management 165