Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1645

logging synchronous Synchronize unsolicited messages and output. C9000 Series Syntax Parameters logging synchronous [level level | all] [limit number-of-buffers] To disable message synchronization, use the no logging synchronous [level level | all] [limit number-of-buffers] command. all level level all limit number-ofbuffers Enter the keyword all to ensure that all levels are printed asynchronously. Enter the keyword level then a number as the severity level. A high number indicates a low severity level and vice versa. The range is from 0 to 7. The default is 2. Enter the keyword all to turn off all. Enter the keyword limit then the number of buffers to be queued for the terminal after which new messages are dropped. The range is from 20 to 300. The default is 20. Defaults Disabled. If enabled without the level or number-of-buffers options specified, level = 2 and number-of-buffers = 20 are the defaults. Command Modes LINE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 7.5.1.0 Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information Related Commands When you enable logging synchronous, unsolicited messages appear between software prompts and outputs. Only the messages with a severity at or below the set level are sent to the console. If the message queue limit is reached on a terminal line and messages are discarded, a system message appears on that terminal line. Messages may continue to appear on other terminal lines. logging on - enables logging. logging trap Specify which messages are logged to the Syslog server based the message severity. C9000 Series Syntax logging trap [level] To return to the default values, use the default logging trap command. Simple Network Management Protocol (SNMP) and Syslog 1645