Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 235

mask any host ip-address destination count bytes dscp order fragments log threshold-in msgs count interval minutes monitor Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or noncontiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets that the filter processes. (OPTIONAL) Enter the keyword byte to count bytes that the filter processes. (OPTIONAL) Enter the keyword dcsp to match to the IP DSCP values. The range is from 0 to 63. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). Enter the keyword fragments to use ACLs to control packet fragments. (OPTIONAL) Enter the keyword log to include ACL matches in the log. (OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate the maximum number of ACL logs that can be generated, exceeding which the generation of ACL logs is terminated with the seq, permit, or deny commands. The threshold range is from 1 to 100. (OPTIONAL) Enter the keyword interval followed by the time period in minutes at which ACL logs must be generated. The threshold range is from 1 to 10 minutes. (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. For more information, refer to the "Flow-based Monitoring" section in the Port Monitoring chapter of the Dell Networking OS Configuration Guide. Defaults Not configured. Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.3.1.0 8.2.1.0 8.1.1.0 7.6.1.0 7.5.1.0 6.5.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Add the DSCP value for ACL matching. Allows ACL control of fragmented packets for IP (Layer 3) ACLs. Introduced on the E-Series ExaScale. Introduced on the S-Series. Introduced on the C-Series. Expanded to include the optional QoS order priority for the ACL entry. Usage Information Use the order option only when you use policy-based QoS on the switch. For more information, refer to the Quality of Service chapter of the C9000 Series Configuration Guide. Access Control Lists (ACL) 235