Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 876

Usage Information Related Commands Version Version 7.8.1.0 Version 7.7.1.0 Description Introduced on the C-Series and S-Series. Introduced on the E-Series. Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups. You may not use extended access lists with this command. When you configure a static SSM map and the router cannot find any matching access lists, the router continues to accept (*,G) groups. ip access-list standard - creates a standard access list to filter based on IP address. ip igmp static-group Configure an IGMP static group. C9000 Series Syntax Parameters ip igmp static-group {group address [exclude [source address]] | [include {source address}]} To delete a static address, use the no ip igmp static-group {group address [exclude [source address]] | [include {source address}]} command. group address exclude source address include source address Enter the group address in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword exclude then the source address, in dotted decimal format (A.B.C.D), for which a static entry is added. (OPTIONAL) Enter the keyword include then the source address, in dotted decimal format (A.B.C.D), for which a static entry is added. Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.5(0.1) 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 7.5.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Expanded to support the exclude and include options. Usage Information A group in include mode must have at least one source address defined. In exclude mode, if you do not specify a source address, The system implicitly assumes all sources are included. If you do not specify either include or exclude, the system implicitly assumes a IGMPv2 static join. Command Limitations 876 Internet Group Management Protocol (IGMP)