Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 737

Example ● True - port is tagged ● False - port is untagged ● Hybrid - port accepts both tagged and untagged frames The following describes the interface vlan command shown in the following example. This example shows unconfiguration of the hybrid port using the no portmode hybrid command. NOTE: Remove all other configurations on the port before you can remove the hybrid configuration from the port. Dell(conf)# interface te 2/0 Dell(conf-if-te-2/0)# portmode hybrid Dell(conf-if-te-2/0)# interface vlan 10 Dell(conf-if-vl-10)# untagged te 2/0 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# tagged te 2/0 Dell(conf-if-vl-20)# Example Dell(conf-if-vl-20)# do show interfaces switchport Name: TenGigabitEthernet 2/0 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 Dell(conf-if-vl-20)# Example (Vlan) Dell(conf-if-vl-20)# interface vlan 10 Dell(conf-if-vl-10)# no untagged te 2/0 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# no tagged te 2/0 Dell(conf-if-vl-20)# interface te 2/0 Dell(conf-if-te-2/0)# no portmode hybrid Dell(conf-if-vl-20)# Related Commands ● show interfaces switchport - displays the configuration of switchport (Layer 2) interfaces on the switch. ● switchport - places the interface in a Layer 2 mode. ● vlan-stack trunk - specifies an interface as a trunk port to the Stackable VLAN network. rate-interval Configure the traffic sampling interval on the selected interface. C9000 Series Syntax Parameters rate-interval seconds seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299 seconds. NOTE: Because polling occurs every 15 seconds, the number of seconds designated here rounds to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59 seconds rounds to 45. Defaults 299 seconds Command Modes INTERFACE Interfaces 737