Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1058

Version 7.7.1.0 7.6.1.0 7.4.1.0 Description Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. management-interface Enable and configure LLDP protocol parameters on the management interface. C9000 Series Syntax management-interface To remove LLDP configuration on a management interface, use the no management-interface command. Command Modes LLDP (conf-lldp) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 9.2(0.0) Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000 and S4810. Usage Information To enable LLDP on the management interface, use the no disable command in LLDP-MANAGEMENTINTERFACE mode (conf-lldp-mgmtIf). mode To receive or transmit, set LLDP. C9000 Series Syntax Parameters mode {tx | rx} To return to the default, use the no mode {tx | rx} command. tx Enter the keyword tx to set the mode to transmit. rx Enter the keyword rx to set the mode to receive. Defaults Both transmit and receive. Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. 1058 Link Layer Discovery Protocol (LLDP)