Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1150

IPv6 Object Tracking Commands The following section describes the IPv6 object tracking commands. The following object tracking commands apply to IPv4 and IPv6: ● debug track ● delay ● description ● show running-config track ● threshold metric ● track interface line-protocol show track ipv6 route Display information about all tracked IPv6 routes, including configuration, current tracked state (UP or DOWN), and the clients which are tracking an object. C9000 Series Syntax Parameters show track ipv6 route [brief] brief (OPTIONAL) Display a single line summary of information for tracked IPv6 routes. Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.8(0.0) 9.7(0.0) 8.3.12.0 8.4.1.0 Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the S4810. Introduced. Usage Command The following table describes the show track ipv6 route command shown in the following example. Output Description Track object-id Displays the number of the tracked object. Interface type slot/port, IP route ip-address, IPv6 route ipv6address Displays the interface type and slot/port number or address of the IPv4/IPv6 route that is being tracked. object is Up/ Down Up/Down state of tracked object; for example, IPv4 interface, reachability, or metric threshold of an IP route. number changes, Number of times that the state of the tracked object has changed and the time last change time since the last change in hours:minutes:seconds. First hop interface Displays the type and slot/port number of the first-hop interface of the tracked route. 1150 Object Tracking