Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 231

Command Modes ● EXEC ● EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.11.1 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 7.4.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the E-Series ExaScale Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information Related Commands When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence number to entries of an existing prefix list. resequence access-list - resequences an access-list. seq Assign a sequence number to a deny or permit filter in an IP access list while creating the filter. C9000 Series Syntax Parameters seq sequence-number {deny | permit} {source [mask] | any | host ipaddress}} [count [bytes]] [dscp value] [order] [fragments] [log [interval minutes] [threshold-in-msgs [count]] [monitor] To delete a filter, use the no seq sequence-number command. sequencenumber deny permit source mask any host ip-address count bytes Enter a number from 0 to 4294967290. Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this criteria. Enter an IP address in dotted decimal format of the network from which the packet was received. (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address or hostname. (OPTIONAL) Enter the keyword count to count packets the filter processes. (OPTIONAL) Enter the keyword bytes to count bytes the filter processes. Access Control Lists (ACL) 231