Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1348

Usage Information Example You can connect to an attached PE through Telnet using the connect pe command and view information specific to the PE system. After you log in to a port extender, enter ? or help to display a list of supported commands. Dell#connect pe 254 Login: peadmin Password: DellPE> feature extended-bridge Enable 802.1BR (bridge port extender) support on the switch. C9000 Series Syntax [no] feature extended-bridge To disable 802.1BR support on the switch, use the no feature extended-bridge command. Default None Command Modes CONFIGURATION CONFIGURATION TERMINAL BATCH Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.10(0.0) 9.9(0.0) Introduced the Configuration Terminal Batch mode on C9010. Introduced on the C9010. Usage Information Example This command enables support for the 802.1 bridge PE (BR) on the switch. Enabling the PE feature allows you to provision the PE. The no feature extended-bridge command disables bridge PE support and deprovisions a PE. When you use this command in the Configuration Terminal Batch mode, you can enable the support for the bridge PE connected in a Dual-Homing setup. You can use the show feature command to check whether the extended-bridge feature has been enabled as shown in the following example. Dell>show feature Feature ------VRF Extended-Bridge State ----disabled enabled Related Commands pe provision - Logically provision or add a PE. 1348 Port Extenders (PE)