Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 692

Related Commands ● Leave All Timer - The Leave All timer starts when a GARP application entity starts. When this timer expires, the entity sends a Leave-all message so that other entities can reregister their attribute information. Then the Leave-all time begins again. show garp timers - displays the current GARP times. gvrp enable Enable GVRP on physical interfaces and LAGs. C9000 Series Syntax gvrp enable To disable GVRP on the interface, use the no gvrp enable command. Defaults Disabled. Command Modes CONFIGURATION-INTERFACE Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 7.6.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on C-Series, E-Series, and S-Series Related Commands disable - globally disables GVRP. gvrp registration Configure the GVRP register type. C9000 Series Syntax Parameters gvrp registration {fixed | normal | forbidden} To return to the default, use the gvrp register normal command. fixed normal forbidden Enter the keyword fixed then the VLAN range in a comma-separated VLAN ID set. Enter the keyword normal then the VLAN range in a comma-separated VLAN ID set. This setting is the default. Enter the keyword forbidden then the VLAN range in a comma-separated VLAN ID set. 692 GARP VLAN Registration (GVRP)