Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 385

Related Commands set weight - assigns a weight to all paths meeting the route map criteria. network Specify the networks for the BGP process and enter them in the BGP routing table. C9000 Series Syntax Parameters network ip-address mask [route-map map-name] To remove a network, use the no network ip-address mask [route-map map-name] command. ip-address mask route-map mapname Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). (OPTIONAL) Enter the keyword route-map then the name of an established route map. Only the following ROUTE-MAP mode commands are supported: ● match ip address ● set community ● set local-preference ● set metric ● set next-hop ● set origin ● set weight If the route map is not configured, the default is deny (to drop all routes). Defaults Not configured. Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.8(0.0) 9.7(0.0) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 7.8.1.0 7.7.1.0 Introduced on the C9010. Introduced on the S3048-ON and S4048-ON. Introduced on the S6000-ON. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Border Gateway Protocol 385