Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 375

neighbor shutdown - disables a peer or peer group. neighbor peer-group passive Enable passive peering on a BGP peer group, that is, the peer group does not send an OPEN message, but responds to one. C9000 Series Syntax Parameters neighbor peer-group-name peer-group passive [sessions] To delete a passive peer-group, use the no neighbor peer-group-name peer-group passive command. peer-group-name Enter a text string up to 16 characters long as the name of the peer group. Defaults Not configured. Command Modes ROUTER BGP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.8.0 8.3.7.0 7.8.1.0 7.7.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced the limit keyword on the S4810. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Usage Information Related Commands After you configure a peer group as passive, assign it a subnet using the neighbor softreconfiguration inbound command. For passive eBGP limits, the Remote AS must be different from the AS for this neighbor. neighbor soft-reconfiguration inbound - assigns a subnet to a dynamically configured BGP neighbor. neighbor remote-as - assigns an indirectly connected AS to a neighbor or peer group. neighbor remote-as Create and specify the remote peer to the BGP neighbor. C9000 Series Syntax neighbor {ip-address | peer-group-name} remote-as number To delete a remote AS entry, use the no neighbor {ip-address | peer-group-name} remote-as number command. Border Gateway Protocol 375