Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 284

Example Version 7.8.1.0 7.6.1.0 7.5.1.0 6.1.1.0 Description Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Dell#show ip prefix summary Prefix-list with the last deletion/insertion: test ip prefix-list test: count: 3, range entries: 1, sequences: 5 - 15 ip prefix-list test1: count: 2, range entries: 2, sequences: 5 - 10 ip prefix-list test2: count: 1, range entries: 1, sequences: 5 - 5 ip prefix-list test3: count: 1, range entries: 1, sequences: 5 - 5 ip prefix-list test4: count: 1, range entries: 1, sequences: 5 - 5 ip prefix-list test5: count: 1, range entries: 1, sequences: 5 - 5 ip prefix-list test6: count: 1, range entries: 1, sequences: 5 - 5 Dell# Route Map Commands When you create an access-list without any rule and then apply the list to an interface, the ACL behavior reflects implicit permit. To configure route maps and their redistribution criteria, use the following commands. continue To a route-map entry with a higher sequence number, configure a route-map. C9000 Series Syntax Parameters continue [sequence-number] sequencenumber (OPTIONAL) Enter the route map sequence number. The range is from 1 to 65535. Defaults Not configured. Command Modes ROUTE-MAP Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. 284 Access Control Lists (ACL)