Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 1437

Usage Information Related Commands Version 7.5.1.0 6.1.1.1 Description Introduced on the C-Series. Introduced on the E-Series. This command assigns a class map or QoS policy to different queues. There are eight queues per interface on the Z9500. ● class-map- identifies the class map. ● service-policy input- applies an input policy map to the selected interface. ● service-policy output- applies an output policy map to the selected interface. set Mark outgoing traffic with a differentiated service code point (DSCP) or dot1p value. C9000 Series Syntax Parameters set {ip-dscp value | mac-dot1p value} ip-dscp value mac-dot1p value (OPTIONAL) Enter the keywords ip-dscp then the IP DSCP value. The range is from 0 to 63. Enter the keywords mac-dot1p then the dot1p value. The range is from 0 to 7. Defaults none Command Modes CONFIGURATION (conf-qos-policy-in) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.19.0 8.3.11.1 8.3.7.0 8.2.1.0 7.6.1.0 7.5.1.0 7.4.1.0 6.1.1.1 Introduced on the C9010. Introduced on the Z9500. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Added mac-dot1p on the C-Series and S-Series. Introduced on the S-Series. Introduced on the C-Series. E-Series Only: Added support for mac-dot1p. Introduced on the E-Series. Usage Information After the IP DSCP bit is set, other QoS services can then operate on the bit settings. Quality of Service (QoS) 1437